Denon DCD-695 Instrucciones De Operación página 12

ENGLISH
THE COMPACT DISC
1. Precautions on handling compact discs
e Do not allow fingerprints, oil or dust on the surface of the
compact disc. If the signal surface is dirty, wipe it off with a
soft, dry cloth. Wipe in circular motions from the center and
out.
e Do not use water, benzene, thinner, record sprays, elec-
trostatic proof chemicals, or silicone-treated cloth to clean
discs.
e Always use care when handling discs to prevent damaging
the surface, in particular when removing a disc from the
case and returning it.
Do not bend compact discs.
Do not apply heat to compact discs.
Do not enlarge the hole in the center of the disc.
Do not write on the disc and do not attach any labels.
Condensation will form on the disc surface if it is brought
into a warm room from a cold area, such as outdoors
during winter. Wait until the condensation disappears.
Never dry discs with hair dryers, etc.
2. Precautions on storage
e After playing a disc, always return it to its case.
e Keep discs in the cases when they are not to be played. This
will protect them from dust and dirt and prolong their
service life.
e@ Do not store discs in the following places:
1) Places exposed to direct sunlight for a considerable
time.
2) Places subject to accumulation of dust or high humidity.
3) Places exposed to high temperatures, such as close to
heater outlets.
PLAYBACK USING THE REMOTE CONTROL UNIT
The accessory RC-241 remote control unit can be used to control
the CD player from a convenient distance.
(1) Inserting the dry cell batteries
1. Remove the battery cover on the back of the remote
control unit.
2. Insert two R03 (standard size AAA) dry cell batteries with
correct polarity as indicated inside the battery compart-
ment.
12
Notes on the Batteries
e The remote control unit uses standard size AAA dry cell
batteries.
e Batteries are prone to damage and leakage.
Therefore:
e Do not combine new batteries with used ones.
e@ Do not combine different types of batteries.
e Do not jumper opposite poles of the batteries, expose them
to heat, break them open nor expose of them in open fire.
(2) Directions for Use
© Operate the remote control unit while pointing it towards the
remote control sensor on the CD player (see below).
indicator on front of the CD player lights briefly.
However, the following functions cannot be remote control-
led: Power ON/OFF.
Right 30°
Remote control sensor Left 30°
Notes on Operation
e Do not press identical buttons on the CD player and remote
control unit simultaneously as this may cause malfunction.
¢ The remote control unit may be difficult to operate if the
remote control sensor is exposed to strong light, such as direct
sunlight or
light from fluorescent
lamps,
or if there
are
obstacles between the remote control unit and the sensor.
e Direct track selection
Using the track number buttons (1 ~
10, +10), tracks can be
directly assigned for playback.
e Track selection while programming
Press the program button (PROG) and then the track numbers
you wish to enter into the memory.
Example:
PROG ~ 3 > +10 &®1—>5
....
(Tracks 3, 11, 5 and so on are entered into the
memory.)
Memorized tracks are erased by pressing the Direct button
(DIRECT).
e Correct use of the track number buttons
Direct selection of single-digit tracks is easy by just pressing
the desired track number button. For tracks with numbers
from
11 and on, first press the +10
button and then a
single-digit button. E.g., to select track 22, press the +10
button twice and then press the 2 button.