Denon DCD-695 Instrucciones De Operación página 8

ENGLISH
Connection Precautions
Before proceeding with connections or disconnections of
cables and power cords, be sure to turn all system compo-
nents off.
Ensure that all cables are connected properly to the L (left) and
R (right) jacks.
Insert plugs fully into the terminals.
Connect the output jacks to the amplifier CD, AUX or TAPE
PLAY input jacks.
(2) SYNCHRO Jack Connections
Connect the SYNCHRO jack with a DENON cassette deck
which is equipped with a SYNCHRO jack, then make a
synchronized recording. Use the connection cord supplied
with the cassette deck.
To make use of this function, also connect the output jacks
and make the settings so that a recording can be made from
the CD player to the cassette deck.
DCD-695/595
(3) Connecting the Digital Output Jack (COAXIAL) (DCD-695
only)
Use a 75-ohm pin cord to connect the digital output jack
(COAXIAL) of the DCD-695 to the digital input jack (COAXIAL)
on a digital processor or D/A unit, available in stores.
DCD-695
aC OUTLET
Digital processor or D/A unit (Amplifier)
OPENING AND CLOSING THE DISC HOLDER AND
LOADING A DISC
Opening and closing the disc holder (This operation only works
while the power is on.)
1.
2.
Press the power switch (POWER) to turn on the power.
Press the open/close button ( 4 OPEN/CLOSE).
How to load a disc
Make sure the disc holder is completely open.
Hold the disc by the edges and place it on the disc tray. (Do not
touch the signal surface, i.e., the glossy side.)
When using 12 cm. diameter discs, make sure the outer edge
matches the tray guide circumference (Fig. 1), and when using
CD singles (8 cm. diameter) match the outer edge with the
inner tray guide circumference. (Fig. 2)
Press the open/close button ( 48 OPEN/CLOSE) to close the
disc holder.
When the disc holder is closed, the disc is read and after a few
seconds the number of tracks and total playing time are
displayed on the TRACK NO. and TIME displays, respectively.
When the disc holder is open and a disc is loaded, you may
also press the play ( ® PLAY) or pause ( I] PAUSE) button to
close the disc holder. (if the play button ( >» PLAY) is pressed,
playback will start immediately upon the disc contents having
been read.)
Fig. 1
Tray guide for 12 cm disc
12 cm disc
8 cm disc eremudise
(CD single)
Caution:
e If your finger should get caught in the disc holder when it
closes, press the open/close button ( OPEN/CLOSE).
Do not place any foreign objects on the disc tray, and do not
place more than one disc on the tray at a time. Otherwise
malfunction may occur.
Do not push in the disc tray manually when the power is off as
this may cause malfunction and damage the CD player.