EMERGENCIES:
if a gas leakcannot be stopped,or a fire occursdue to gas leakage,call the fire department.
Gas leakingfrom
cracked/cut/burned hose.
Gasleaking from LP cylinder.
Gas leakingfrom LP
cylindervalve.
Gas leaking betweenLP
cylinderand regulator
connection.
Fire comingthroughcontrol
panel.
Greasefire or continuous
excessiveflamesabove
cookingsurface.
, Damagedhose.
, Mechanical f ailure due to rusting or mishandling.
, Failureof cylindervalvefrom mishandlingor
mechanicalfailure.
, Improperinstallation,connectionnot tight, and/or
failure of rubber seal.
, Fire in burnertube sectionof burnerdue to blockage.
, Toomuch greasebuildupin burner area.
,Turnoff gas at LP cylinderor at source on naturalgas systems. Discontinueuse of
productand replacevalve/hose/regulator.Oncevalve/hose/regulator r eplaced
conductcompleteleak check per manual.
, ReplaceLPcylinder.
, Turnoff LPcylinder valve. Return LPcylinderto gas supplier.
, Turnoff LP cylindervalve. Remove regulatorfrom cylinder andvisually inspect rubber
sealfor damage.See LP CylinderLeakTestand ConnectingRegulatorto the LP
Cylinder.
, Turnoff controlknobsand LP cylindervalve. Leavelid open to allow flamesto die
down.Afterfire is out and grill is cold. removeburner and inspectfor spidernests or
rust. SeeNaturalHazardand Cleaningthe BurnerAssemblypages.
, Turnoff control knobsand LPcylinder valve. Leave lid opento allow flamesto die
down.After cooling,clean food particlesandexcess greasefrom insidefirebox area,
greasetray,and other surfaces.
Troubleshooting
Burner(s)will not light
usingignitor.
(SeeElectronicIgnition
Troubleshootingalso)
Continuedon next page.
Burner(s)will not match light.
GASiSSUES:
, Tryingto lightwrong burner.
, Burnernot engagedwith controlvalve.
, Obstructionin burner.
, Nogas flow.
, Vaporlock at couplingnut to LPcylinder.
, Couplingnut and LP cylindervalvenot fully
connected.
ELECTRICALISSUES:
, Electrodecrackedor broken;"sparksat crack."
, Electrodetip not in proper position.
(Doesnot applyto SUREFIRE.)
, Wire and/orelectrodecoveredwith cookingresidue.
, Wires are loose or disconnected.
, Wiresare shorting (sparking)betweenignitor and
electrode.
, Deadbattery.
ELECTRONIC IGNmON:
, No spark, no ignition noise.
, No spark, some ignition noise.
, Sparks,but not at electrodeor at full strength.
, See "GAS ISSUES:".
, Match will not reach.
, Impropermethodof match-lighting.
, See instructionson control paneland in Use andCare section.
, Makesure valvesare positionedinside of burnertubes.
, Ensureburner tubes are not obstructedwith spiderwebs or othermatter.See
cleaningsection of Useand Care.
, Makesure LP cylinderis notempty. If LP cylinderis not empty,referto
"Suddendrop ingas flow."
, Turn off knobsand disconnectcouplingnut from LP cylinder.Reconnectand retry.
, Turnthe couplingnut approximatelyone-halfto three-quartersadditionalturn until
solidstop. Tightenby handonly -do not use tools.
, Replaceelectrode(s).
MainBurners:
, Tipof electrodeshouldbe pointingtowardgas port openingon burner.The
distance shouldbe 118"to 1/4".Adjustif necessary.
Sideburner:
, Tip of electrodeshould be pointingtoward gas portopening on burner,the
distanceshould be 1/8" to 3/16".Adjust if necessary.
, Clean wire and/or electrodewith rubbingalcoholand clean swab.
, Reconnectwiresor replace electrode/wire assembly.
, Replaceignitorwire/electrodeassembly.
, Replacewith a new alkalinebattery.
, SeeSectionI of ElectronicIgnitionSystem.
, SeeSectionII of ElectronicIgnitionSystem.
, See SectionIII of ElectronicIgnitionSystem.
, Use long-stemmatch(fireplacematch).
, See "Match-Lighting" s ection of Useand Care.
37