Cuisinart MINI PREP PRO ECH4 Serie Instrucciones página 21

4. INSTRUCTIONS FOR USE
SAFETY DURING USE
• Handle the blade with extreme care, it is very sharp.
• Never place the blade directly on the motor of the housing base. Always ensure the bowl is in
place.
• Always carefully insert the blade before adding the ingredients.
• Take extra care if using the appliance to process hot liquids. A build up of steam could cause
liquid to be ejected from the appliance.
• Always wait for the blade to stop before removing the lid.
• Always remove the bowl from the motor base very carefully before removing the blade.
• Never leave the appliance unattended when switched on or plugged in.
• Keep hands, spatulas and other utensils away from moving blades whilst appliance is in
operation. Only use the spatula once the processor motor has stopped.
• Unplug the unit before cleaning it or removing the blades.
• Always ensure the blades and bowl have been thoroughly cleaned after each use and have dried
completely before storing.
A. FITTING & REMOVING THE PARTS
1. Place the housing base on a fl at, dry, stable surface.
2. Place the work bowl over the motor base with the handle facing forward and positioned slightly
to the left of the control panel (the bowl will slot onto the base).
3. Turn the bowl in an anticlockwise direction until it locks into position on the housing base.
N.B. The work bowl must be securely locked into position. The bowl will be in the correct position
once the handle is central to the control panel.
4. Carefully lift the blade assembly, holding the central plastic stem and place over the motor
spindle. Push the blade down until it clicks into place. The lower part of the blade assembly
should almost touch the bottom of the work bowl.
N.B. Always hold the blade assembly from the plastic stem. Never touch the blade as it is very
sharp.
N.B. Never place the blade on the motor shaft until the work bowl is locked into place.
N.B. Always insert the blade in the work bowl before adding ingredients.
5. Add the food you wish to process.
6. Place the lid on the work bowl with the small tab to the left of the work bowl handle. Turn the
cover anticlockwise (toward handle) to securely lock.
N.B. The work bowl and lid must be tightly locked into the interlock device. Once securely fi tted
a loud click is heard. If both the work bowl and the lid are not fi tted securely the processor may
work intermittently.
7. To remove the lid, hold the housing base with your left hand, securely grip the handle on the
top of the lid and rotate it in a clockwise direction.
N.B. Make sure the motor has completely stopped and the blade has stopped moving before
removing the lid.
ATTENTION: The lid must always be removed before fi tting or removing the work bowl from the
base.
19