Ninja WOODFIRE Manual De Instrucciones página 20

PARTS & ACCESSORIES
A Assembled Main Unit
(power cord not shown)
A
B
Accessory Frame
C
Pizza Stone
D
Pro-Heat Tray
E
Roast Rack
F
Pellet Box
G
Pellet Scoop
H
Power Cord and RCD Plug
I
ON/OFF Switch
C D
F G
To order replacement or additional parts and accessories, visit ninjakitchen.eu
BEFORE FIRST USE
1 Remove all packaging material and tape from the oven.
2 Remove all accessories from the package and read this manual carefully. Please pay particular
attention to operational instructions, warnings, and important safeguards to avoid any injury or
property damage.
3 Rinse the Accessory Frame, Pro-Heat Tray, and Roast Rack in warm, soapy water. Rinse and dry
thoroughly.
NOTE: DO NOT get the Pizza Stone wet or put it in the dishwasher. Place it in the oven after removing
all packaging.
4 DO NOT use abrasive brushes or sponges on the cooking surface. Damage to the coating can occur.
We recommend placing all accessories inside the oven and running
it on the Bake function for 20 minutes at 370°C without adding food.
This removes any residue and is not detrimental to the performance of the oven.
Continue following instructions on page 40 and 41 before attempting to do this.
38 38 ninjakitchen.eu
I (Fig. A)
B
E
RESET
H
TEST
BEFORE FIRST USE
WHERE TO LOCATE THE OVEN
Place oven on a stable and level surface. It is
important this can support the weight and size of
the product. The underside stays cool and so you
can place the oven on any surface. Position the
oven at least 90cm (3 feet) from walls or anything
over head due to heat and smoke output.
USE IN ANY WEATHER
This oven is safe to use in any weather. The main
unit is IPX4 rated and the plug is IP66. The RCD
plug provides additional protection and it is
designed to trip should there be any issue with the
circuit. When not in use we advise you cover the
unit to keep it looking it's best. Whilst the unit is
safe it will show signs of weathering if exposed to
the elements.
EXTENSION CORD
If using an extension cord, ensure it is suitable for
use outdoors with outdoor appliances. Using the
incorrect cord could lead to the cord overheating,
melting and/or a drop in voltage. A drop in voltage
can increase preheat times and impact cooking
performance and/or cook times.
POWERING THE OVEN
1 Plug the RCD into electrical socket. Switch
socket on.
2 Press RESET button on the RCD. The circle above
the RESET button should be illuminated orange.
If this isn't the case, try a different socket. Note:
It may be difficult to see the orange if in direct
sunlight.
RESET
TEST
3 Press the TEST button on the RCD. The circle
should now show black. This means the RCD is
functioning correctly. If pressing the TEST button
does not change the circle to black then contact
customer services.
4 After establishing if the RCD is functioning
correctly once again press RESET. The orange
illumination should re-appear. The unit can now be
switched on.
NOTE: RCD Light;
ORANGE = RCD is ON ; BLACK = RCD is OFF
5 Press the ON/OFF switch on the back
of the control panel. Switch is on
when the side with the line is
pressed down.
6 Now turn the dial on the front of the control panel
and turn it to the desired function. The display
should illuminate to reveal times or temps. The
oven is now ready to use.
NOTE: The RESET button on the RCD will need
to be pressed every time the unit is unplugged or
the socket switched off.
ninjakitchen.eu
39 39