Toro TimeCutter Max 54 Manual Del Operador página 41

Hauling the Machine (continued)
Loading the Machine
Loading a machine onto a trailer or truck increases the possibility of tip-over and
could cause serious injury or death.
• Use extreme caution when operating a machine on a ramp.
• Back the machine up the ramp and drive it forward down the ramp.
• Avoid sudden acceleration or deceleration while driving the machine on a ramp as
this could cause a loss of control or a tip-over situation.
1. If using a trailer, connect it to the towing vehicle and connect the safety chains.
2. If applicable, connect the trailer brakes.
3. Lower the ramp, ensuring that the angle between the ramp and the ground does not
exceed 15 degrees.
4. Back the machine up the ramp.
5. Shut off the engine, remove the key, and move
the motion-control levers outward to the P
position.
6. Tie down the machine using straps, chains,
cable, or ropes. Refer to local regulations for
tie-down requirements.
Unloading the Machine
1. Lower the ramp, ensuring that the angle
between the ramp and the ground does not
exceed 15 degrees.
2. Drive the machine forward down the ramp.
3466-517A
WARNING
ARK
G414592
G451313
G414593
Page 4–19 Operation: After Operation