Toro TimeCutter Max 54 Manual Del Operador página 73

Replacing the Grass Deflector (continued)
4. Slide the rod out.
5. Remove the damaged or worn grass deflector.
6. Install the new grass deflector.
7. Slide the straight end of the rod through the rear grass deflector pivot.
8. Place the spring on the rod, with end wires down, and between the grass deflector
brackets.
9. Slide the rod through the second grass-deflector pivot.
10. Insert the rod at the front of the grass deflector into the bracket on the deck.
11. Secure the rear end of the rod into the mower with the nut.
The grass deflector must be spring-loaded in the down position. Lift the deflector up
to test that it snaps into the full-down position.
Cleaning
Washing the Underside of the Mower Deck
You can wash the machine with a mild detergent and water. Do not pressure wash the
machine. Avoid excessive use of water, especially near the control panel, under the
seat, around the engine, hydraulic pumps, and motors.
3466-517A
G451625
IMPORTANT
IMPORTANT
Page 5–32
Mower deck
Grass-deflector pivot
Grass deflector
Rod
Spring
Nut
Maintenance: Cleaning