Picture Settings Menu; Adjusting The Picture; Setting The Picture Modes According To The Brightness Of The Room; Reducing Noise In The Picture - Pioneer PDP-42MVE1 Manual De Instrucciones

Picture Settings Menu

Adjusting the picture

The contrast, brightness, sharpness, color and tint can be
adjusted as desired.
Example: Adjusting the contrast
On "CONTRAST" of "PICTURE" menu, adjust the contrast.
PICTURE
CONTRAST
BRIGHTNESS
SHARPNESS
COLOR
TINT
AV SELECTION :
DNR :
NEXT PAGE
SEL. ADJ. EXIT RETURN
Note: If "CAN NOT ADJUST" appears ...
When trying to enter the PICTURE submenu, make sure
AV SELECTION is not set to DEFAULT.
Information
Picture adjustment screen
CONTRAST: Changes the picture's white level.
BRIGHTNESS: Changes the picture's black level.
SHARPNESS: Changes the picture's sharpness.
Adjusts picture detail of VIDEO display.
COLOR: Changes the color density.
TINT: Changes the picture's tint. Adjust for natural
colored skin, background, etc.
Adjusting the computer image
Only the contrast and brightness can be adjusted when
a computer signal is connected.
Restoring the factory default settings
Select "DEFAULT" under the "AV SELECTION"
settings.
Setting the picture modes according to the
brightness of the room
There are four picture modes that can be used effectively
according to the environment in which you are viewing
the display.
Example: Setting the "MOVIE 1" mode
On "AV SELECTION" of "PICTURE" menu, select
"MOVIE 1".
PICTURE
CONTRAST
BRIGHTNESS
SHARPNESS
COLOR
TINT
AV SELECTION :
DNR :
NEXT PAGE
SEL. ADJ. EXIT RETURN
Information
Types of AV SELECTIONS
MOVIE 1, 2: Set this mode when watching video in a
dark room.
This mode provides darker, finer pictures, like the
screen in movie theaters.
For a darker image, select MOVIE 2.
STD: Set this mode when watching video in a bright room.
This mode provides pictures with distinct differences
between light and dark sections.
DYNAMIC: This mode provides brighter pictures than
STD.
DEFAULT: Use this to reset the picture to the factory
default settings.
14
En
1 / 2
STD
OFF
CONTRAST
1 / 2
STD
OFF
AV SELECTION :

Reducing noise in the picture

Use these settings if the picture has noise due to poor
reception or when playing video tapes on which the picture
quality is poor.
Example: Setting "HIGH"
On "DNR" of "PICTURE" menu, select "HIGH".
PICTURE
CONTRAST
BRIGHTNESS
SHARPNESS
COLOR
TINT
AV SELECTION
DNR
NEXT PAGE
SEL. ADJ.
52
Information
DNR
* "DNR" stands for Digital Noise Reduction.
* This function reduces noise in the picture.
Types of noise reduction
There are three types of noise reduction. Each has a
different level of noise reduction.
The effect increases stronger in the order of LOW, MID
and High.
OFF: Turns the noise reduction function off.

Setting the color temperature

Use this procedure to set color tone produced by the plasma
display.
Example: Setting "HIGH"
On "COLOR TEMP." of "PICTURE" menu, select "HIGH".
Information
Setting the color temperature
LOW: Redder
MID LOW: Slightly red
MID: Standard (slightly bluer)
HIGH: Bluer
MOVIE 1
1 / 2
: STD
: OFF
DNR
EXIT RETURN
PICTURE 2 / 2
PREVIOUS PAGE
COLOR TEMP. : HIGH
GAMMA : 2
LOW TONE : AUTO
C.DETAIL ADJ.
SEL. ADJ. EXIT RETURN
: HIGH