Operating Instructions; During Operation; After Finishing Work; Air Filter - Stihl FS 300 Manual De Instrucciones

English
► Swing retainer inward
► Hook retainer into transport guard
13.3 Universal transport guard
2.
► Unhook the retainer on the transport guard
and swing outward
► Fit the transport guard to the cutting attach‐
ment from below as shown in the illustration
► Hook the retainer into the hook of the transport
guard
70
2.
1.
2.

14 Operating Instructions

14.1 During break-in period
A factory-new machine should not be run at high
revs (full throttle off load) for the first three tank
fillings. This avoids unnecessary high loads dur‐
ing the break-in period. As all moving parts have
to bed in during the break-in period, the frictional
resistances in the engine are greater during this
period. The engine develops its maximum power
after about 5 to 15 tank fillings.
14.2

During Operation

After a long period of full throttle operation, allow
the engine to run for a short while at idle speed
so that engine heat can be dissipated by the flow
of cooling air. This protects engine-mounted
components (ignition, carburetor) from thermal
overload.
14.3

After Finishing Work

Storing for a short period: Wait for the engine to
cool down. Empty the fuel tank and keep the
machine in a dry place, well away from sources
of ignition, until you need it again. For longer out-
of-service periods – see "Storing the Machine".

15 Air filter

15.1 If there is a noticeable loss of
engine power
14 Operating Instructions
0458-579-8721-B