Operating Instructions - Stihl FS 300 Manual De Instrucciones

English
Swing retainer outward
N
Fit the transport guard to the cutting
N
attachment from below, ensuring
that the stop is centered in the
recess
Swing retainer inward
N
Hook retainer into transport guard
N
74
Universal transport guard
2.
Unhook the retainer on the transport
N
guard and swing outward
2.
Fit the transport guard to the cutting
N
attachment from below as shown in
the illustration
Hook the retainer into the hook of
N
the transport guard

Operating Instructions

During break-in period
A factory-new machine should not be
run at high revs (full throttle off load) for
the first three tank fillings. This avoids
unnecessary high loads during the
break-in period. As all moving parts
have to bed in during the break-in
period, the frictional resistances in the
engine are greater during this period.
The engine develops its maximum
power after about 5 to 15 tank fillings.
1.
During Operation
After a long period of full throttle
operation, allow the engine to run for a
short while at idle speed so that engine
heat can be dissipated by the flow of
cooling air. This protects engine-
mounted components (ignition,
carburetor) from thermal overload.
After Finishing Work
Storing for a short period: Wait for the
engine to cool down. Empty the fuel tank
2.
and keep the machine in a dry place,
well away from sources of ignition, until
you need it again. For longer out-of-
service periods – see "Storing the
Machine".
FS 300, FS 350, FS 380