Publicidad
Idiomas disponibles
Idiomas disponibles
HYSTERISIS THRESHOLDS (fig. 31)
Depending on programming and the room
temperature detected, the remote control
will generate the central heating request
with hysteresis. Using the [CONFIG.] key,
access "CONFIGURATION" of the remote
control. Here it is possible to select the H1
or H0 value using the [S] key:
- H0: Select the H0 threshold value using
the [ + ] and [ - ] keys. Possible values (°C):
0. 1 -0.2-0.3-0.4-0.5. Press the [S] key to
set H1.
- H1: Select the H1 threshold value using
the [ + ] and [ - ] keys. Possible values (°C):
0. 1 -0.2-0.3-0.4-0.5. Press the [OK] key to
escape.
CONTROLS (fig. 32)
Programming and use of the device are
explained in a standard manner and graphi-
cally with certain simple commonly used
symbols.
In programming and configuration, only
what is significant for the operation in que-
stion is displayed, and what is being modi-
fied flashes on and off ("blink" effect).
LANGUAGE/DATE/TIME SETTING
The key [CONFIG.] gives access to the
"CONFIGURATION" of the remote control,
where it is possible to:
– select the day display mode: Italian or
English
– set the current day of the week
– set the current hour
– set the current minutes
– select
the
time
0-24/AM-PM
– total resetting of the device or the manu-
facturer's setting
To exit the function, press the [CONFIG.] key
again.
The flashing part of the display is in grey
LANGUAGE
[ + ] and [ - ]: to select Italian or English
[OK]: proceed with setting the day
[CONFIG.]: exit configuration
82
display
mode:
[ + ] and [ - ]: to set the day
[OK]: allows to proceed with setting the
time
[CONFIG.]: exit configuration mode
Central heating
Richiesta di
request
riscaldamento
ON
H1
Plant filling
RIEMP.
Heating setting
RISC
Sanitary water setting
SAN
DAY
Central heating
Richiesta di
request
riscaldamento
OFF
H0
SET
Change of functioning
M
mode
+
Increase
ok
Confirmation
–
Decrease
S
Next page
Configuration
CONFIG.
Reset
reset
Programming
PROG.
Paste
Incolla
Copy
Copia
TIME
[ + ] and [ - ]: to set the hour
[OK]: allows to proceed with setting the
minutes
[CONFIG.]: exit configuration mode
T
Fig. 31
Fig. 32
Publicidad
