Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
5.2.3 Main parameters setting
5.2.3.1 Operation Mode
1 Select the target group for the change of operation mode settings at the "Monitor (All Groups)" or "Monitor (Block)" screens. The
screen with the settings for the selected group is displayed on the touchscreen.
Monitor (All Groups)
(1)
2 By tapping the " " or " " buttons under "Operat Mode", operation mode changes alternatively as shown below:
The "AUTO" (Heating/Cooling Automatic Operation) is also included as an option when applicable.
3 Tap "Monitor screen" to return to Monitor screen.
?
N O T E
•
By tapping "<" or ">" at the detailed setting screen, the operation mode is switched to another group in the same block.
•
Control Restricted (Run/Stop Only): In case of "Enable", each Setting Change is for all Groups or Blocks. Setting Change is not possible for each
Group.
•
Some operation mode cannot be set depending on the type of Air Conditioner Unit. Contact your dealer or go to the inquiry counter of a designated
maker for detailed information.
•
If the settings are mixed when multiple groups are selected, the display remains blank.
34
PMML0332A rev.0 - 05/2015
(3)
(2)
COOL
HEAT
DRY
AUTO
FAN
Monitor (Block)
(1)
Publicidad
