Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
3 Tap "Monitor screen" to return to the "Monitor" screen.
?
N O T E
•
By tapping "<" or ">" at the detailed setting screen, the remote control switch Permitted/ Prohibited will be switched to another group in the same
block.
•
Control Prohibited (Run/Stop Only) : In case of "Enable", each Setting Change is for all Groups or Blocks. Setting Change is not possible for each
Group.
•
Even if remote control switch is set as "Prohibit.", it is possible to stop operation with the remote control switch while running. It is also possible
to restart operation using the remote control switch. However, the Stop operation will be only used in the case of an emergency. Do not use it in
normal operation.
•
If "Power Supply ON/OFF" (d1, d3) is set, do not set the remote control switch as "Prohibit.". If the remote control switch is restricted when using
"Power Supply ON/OFF", the function "Control lock" for the remote control switch shall be used.
•
If a communication error occurs, the remote control switch "STOP" (by item) may be cancelled. In this case, do the setting again.
•
Do not set the prohibiting operation if multiple centralised controllers are used in the same H-LINK. Additionally, do not set this by other centralised
controller or it may cause malfunction.
39
PMML0332A rev.0 - 05/2015
(3)
Publicidad
