Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
5.4.3 Exception Setting of Run/Stop Operation
"RUN" and "STOP" orders are not accepted when the group is set to operation in "All groups" or "All blocks".
However, it is possible to set an exception rule for any of the following orders or combinations of orders, affecting specific groups:
•
None
•
Run + Stop
•
Stop
•
Run
?
N O T E
•
The following commands are affected when this function is set.
- Scheduled Timer Operation.
- "All Run/Stop" and "Run/Stop by Block" by External Input command.
•
"Run/Stop" operation is available when the group is selected individually.
1 Select "Exception Setting of Run/Stop Operation" on the "Service Menu" screen.
2 Select the operation to exclude. The selected operation is highlighted in yellow.
3 Select the target for the rule of exception for the selected operation (group/block)
•
Tap on a Group button to switch the selection state of that group.
•
Tap on a Block button to switch the selection state of all the groups in that block.
•
The selected groups are indicated with a check mark.
4 Tap "Setting completed" to confirm the set contents and to return to the "Exception setting of Run/Stop Operation" screen.
69
PMML0332A rev.0 - 05/2015
(1)
(3)
(2)
(4)
Publicidad
