Publicidad
Idiomas disponibles
Idiomas disponibles
Locking pin
Pull
2
5. Installing the dust bag, side holder, stopper and vises
(The stopper is an optional accessory.)
To empty the dust bag, pull out the dust bag
assembly from dust port. Open zipper on underside of
bag and empty into waste container. Check
frequently and empty the dust bag before it gets
full.
When bevel angle cutting, adjust the support bar and
install the dust bag so that it hangs down vertically.
Vertical
Dust bag
Support bar
WARNING
Do not use this saw to cut and/or sand metals.
The hot chips or sparks may ignite saw dust
from the bag material.
CAUTION
● Empty the dust bag frequently to prevent the
duct and the lower guard from becoming
clogged.
Sawdust will accumulate more quickly than
normal during bevel cutting.
Handle
Fig. 14
Gear case
Dust port
Fig. 15
● After cutting wood, before starting to cut
aluminum sash, discard the chips that are in the
dust bag.
(Attach the vise assembly as shown in Fig. 3, Fig. 4 and
Fig. 31.)
1
BEFORE USING
WARNING
Check steps 1 through 7 before you have
installed the power supply (battery) to the tool.
1. Make sure the trigger switch is turned OFF.
WARNING
If the battery is inserted while the power switch
is in the ON position, the power tool will start
operating immediately, inviting serious accident.
2. Check the saw blade for visible defects.
Confirm that the saw blade is free of cracks or other
visible damage.
3. Confirm that the saw blade is attached securely to the
power tool.
Using the supplied 8 mm hex. bar wrench, tighten the
left hex. 10 mm socket bolt on the saw blade spindle
to secure the saw blade.
For details, see Fig. 59-a, Fig. 59-b, and Fig. 59-c in
the section on "SAW BLADE MOUNTING AND
DISMOUNTING".
4. Check the lower guard for proper operation.
WARNING
NEVER OPERATE THE POWER TOOL if the lower
guard does not function smoothly.
Lower guard is designed to protect the operator from
coming into contact with the saw blade during operation of
the tool.
Always check that the lower guard moves smoothly and
covers the saw blade properly.
English
21
Publicidad
