Metabo HPT C3612DRA Manual página 25

6. Oblique angle
WARNING
When changing the oblique angle, hold down the
motor head. If the motor head moves to an
oblique angle suddenly, it may result in injury or
damage to the main body.
Before the power tool is shipped from the factory, it is
adjusted for 0°, right angle, left 45° bevel cutting
angle and right 45° bevel cutting angle with the 8 mm
set screws.
When changing the adjustment, change the height of
the 8 mm set screws by turning them. (Fig. 21-a,
Fig. 21-b)
When changing the bevel angle to the left 45°, loosen
the 6 mm wing bolt shown in Fig. 20, then slide the
sub fence (B) outward and incline the motor head to
the left.
To change the bevel angle to the right at 45°, move
the sub fence (A) outward and loosen the bevel lock
handle, then pull out the set pin (A) toward the front,
and tilt the motor head to the right. (Fig. 21-b)
When the motor head is straight upright, the set pin
(A) is held tightly in place, so tilt the motor head
slightly to the left when pulling out the set pin (A)
before tilting the motor head to the right.
When adjusting the motor head to 0°, always return
the set pin (A) to its initial position as shown in
Fig. 21-b.
Indicator
(For bevel scale)
8 mm set screw
(For left 45° bevel angle)
Fig. 21-a
8 mm set screw
(For right angle)
8 mm set screw
(For right 45° bevel angle)
7. Securing the workpiece
WARNING
Always clamp or vise to secure the workpiece to
the fence; otherwise the workpiece might be
thrust from the table and cause bodily harm.
8. Installing the side holder
The side holder helps keep longer workpieces stable
and in place during the cutting operation.
As indicating in Fig. 22, installing the side holder in
the holes on the side of base and fasten it with 6 mm
bolt.
6 mm bolt
Side holder
CAUTION
When transporting or carrying the tool, do not
grasp the holder. There is the danger of the
holder slipping out of the base.
For the correct way to hold the tool, refer to
"TRANSPORTATION OF THE MAIN BODY".
English
Indicator
(For bevel scale)
Set pin (A)
Pull
Fig. 21-b
Base
Fig. 22
25