Metabo HPT C3612DRA Manual página 39

4
Make sure the cord is taut!
Secure the cord
with the hook
OPTIONAL ACCESSORIES...sold separately
○ Cord holder (Code No. 338938)
○ FT screw (Code No. 380145)
SAW BLADE MOUNTING AND
DISMOUNTING
WARNING
● To prevent an accident or personal injury, always
turn off the trigger switch and disconnect the
power plug from the receptacle and/or remove
the battery pack before removing or installing a
saw blade.
If cutting work is done in a state where the
10 mm bolt is not sufficiently tightened, the
10 mm bolt can get loose, the blade can come
off, and the lower guard can get damaged,
resulting in injuries.
Also, check that the 10 mm bolts are properly
tightened before plugging the power plug into
the receptacle and/or inserting the battery pack.
● If the 10 mm bolts are attached or detached
using tools other than the 8 mm hex. bar wrench
(standard accessory), excessive or improperly
tightening occurs, resulting in injury.
1. Mounting the saw blade
(1) Press in spindle lock and loosen 10 mm bolt with
8 mm hex. bar wrench (standard accessory).
Since the 10 mm bolt is left-hand threaded, loosen by
turning it to the right as shown in Fig. 59-a, Fig. 59-b.
3
Attach ET36A to
the tool
Fig. 58
NOTE
If the spindle lock cannot be easily pressed in to lock
the spindle, turn the 10 mm bolt with 8 mm hex. bar
wrench (standard accessory) while applying pressure
on the spindle lock.
The saw blade spindle is locked when the spindle
lock is pressed inward.
(2) Remove the bolt and washer (B)
Loosen
Dust guide
8 mm hex. bar
wrench
Saw Blade
10 mm bolt
Washer (B)
English
Spindle lock
Fig. 59-a
Washer (B)
Tighten
10 mm bolt
Fig. 59-b
Washer (A)
Fig. 59-c
39