Publicidad
Idiomas disponibles
Idiomas disponibles
English
Fence
Ⓐ
Cutting method of crown molding without tilting the saw
blade
Crown molding vise ass'y
(optional accessories)
6 mm knob bolt
6 mm wing bolt Crown molding
stopper (L)
(Optional
accessories)
(1) Crown molding Stopper (L) and (R) (optional
accessories) allow easier cuts of crown molding
without tilting the saw blade. Install them in the base
both-sides side to be shown in Fig. 51-a. After
inserting Tighten the 6mm knob bolts to secure the
crown molding Stoppers.
[Optional accessories used]
–
Crown molding Vise Ass'y
–
Crown molding Stopper (L)
–
Crown molding Stopper (R)
(2) The crown molding vise ass'y (Optional accessory)
can be mounted on the base. It can unite with the
slope of the crown molding and vice can be pressed
down.
Then turn the upper knob, as necessary, to securely
attach the crown molding in position. To raise or lower the
vise assembly, first loosen the hex. socket set screw.
After adjusting the height, turn the upper knob, as
necessary, to securely attach the crown molding in
position. (See Fig. 51-b)
36
Ⓑ
Table on base
Fig. 50
6 mm knob bolt
6 mm wing
bolt
Crown molding
stopper (R)
(Optional
accessories)
Fig. 51-a
Hex. socket set
screw
Crown molding
Crown molding stopper (L)
Crown molding stopper (R)
(Optional accessories)
WARNING
Always firmly clamp or vise to secure the crown
molding to the fence; otherwise the crown
molding might be thrust from the table and
cause bodily harm.
Do not bevel cutting. The main body or saw
blade may contact the sub fence, resulting in an
injury.
CAUTION
Always confirm that the motor head (see Fig. 3)
does not contact the crown molding vise ass'y
when it is lowered for cutting. If there is any
danger that it may do so, loosen the hex. socket
set screw and move the crown molding vise
ass'y to a position where it will not contact the
saw blade.
Position crown molding with its WALL CONTACT EDGE
against the guide fence and its CEILING CONTACT
EDGE against the crown molding Stoppers as shown in
Fig. 51-b.
Adjust the crown molding Stoppers according to the size
of the crown molding.
Tighten the 6 mm wing bolt to secure the crown molding
Stoppers.
Refer to the lower table for the miter angle.
Crown molding vise ass'y
(Optional accessories)
Knob
Fig. 51-b
Publicidad
