Metabo HPT C3612DRA Manual página 23

5 mm
machine screw
[Right angle cutting]
(2) Left and right bevel angle cutting
Adjust the table insert in the manner shown in
Fig. 17-b and Fig. 17-c following the same procedure
for right angle cutting.
5 mm
machine screw
[Left bevel angle cutting]
Saw blade
Table insert
[Right bevel angle cutting]
CAUTION
After adjusting the table insert for right angle
cutting, the table insert will be cut to some extent
if it is used for bevel angle cutting.
When bevel cutting operation is required, adjust
the table insert for bevel angle cutting.
2. Checking the saw blade lower limit position
Check that the saw blade can be lowered 10 mm to
11 mm below the table insert.
When you replace a saw blade with a new one, adjust
the lower limit position so that the saw blade will not
cut the turntable or complete cutting cannot be done.
Saw blade
Table insert
Fig. 17-a
Saw blade
Table insert
Fig. 17-b
5 mm
machine screw
Fig. 17-c
Furthermore, when changing the position of an 8 mm
depth adjustment bolt that serves as a lower limit
position stopper of the saw blade.
(1) Turn the 8 mm depth adjustment bolt, change the
height where the bolt head and the hinge contacts,
and adjust the lower limit position of the saw blade.
(Fig. 18-a)
8 mm depth
adjustment bolt Hinge
3. Lower limit position of saw blade when cutting a large
workpiece
When cutting a workpiece 4-7/32" (107 mm) to
4-11/16" (120 mm) in height in right-angle cutting or
2-3/4" (70 mm) to 2-15/16 (75 mm) in left bevel angle
cutting or 1-3/4" (45 mm) to 1-15/16 (50 mm) in right
bevel angle cutting, adjust the lower limit position so
that the base of the motor head (see Fig. 18-a) will not
come in contact with the workpiece.
NOTE
Confirm that the saw blade is adjusted so that it will
not cut into the turntable.
Lower the motor head, and turn the 6 mm depth
adjustment bolt and make adjustments so that there can
be a clearance of 5/64" to 1/8" (2 mm to 3 mm) between
the lower limit position of the motor head and the top of the
workpiece at the saw blade's lower limit position where the
head of the 6 mm depth adjustment bolt contacts the
hinge. (Fig. 18-b)
English
6 mm depth
adjustment bolt
Fig. 18-a
23