Metabo HPT C3612DRA Manual página 45

Problem
Tool suddenly stopped
Cannot be tilted
Cannot be tilted to the right
Sawblade is dull
Cannot cut with precision
Switch can't be pulled
Battery cannot be installed
2. AC/DC adapter
Problem
The adapter's error lamp is blinking
red and the tool does not operate
when switched on.
Possible Cause
Tool was overburdened
The battery is overheated.
The motor was automatically stopped
to prevent failure of the tool.
The bevel lock handle has not been
loosened.
Set pin (A) has not been pulled out.
The bevel lock handle has not been
loosened.
The sawblade is worn down or
missing teeth.
Bolt is loose.
The sawblade has been installed in
reverse.
The operation parts of the tool are not
fully fixed.
Material cannot be fixed in the correct
position.
Switch lock is not pressed in enough.
Attempting to install a battery other
than that specified for the tool.
Possible Cause
Output is suspended because the tool
or the AC/DC adapter is overheated.
Possible Solution
Get rid of the problem causing the
overburden.
Let the battery cool down.
This is not a malfunction.
The trigger switch was held down for
5 minutes or more. Switch on the
power once more.
Loosen the bevel lock handle and
then tilt the tool.
After adjusting the loosened
component, make sure to tighten it
once again.
Tilt to the right after pulling out set pin
(A).
Loosen the bevel lock handle and
then tilt.
Exchange with a new product.
Tighten the bolt.
Install the sawblade in the correct
direction.
Fully install the bevel lock handle and
miter lock handle.
Remove any foreign material from the
fence or turntable.
In some cases, proper position cannot
be fixed due to a curve in the material.
Try to fix a flat surface with the fence
or turntable.
Press in the switch lock all the way
until it strikes the back.
Please install a multi volt type battery.
Possible Solution
Allow the tool and AC/DC adapter to
sufficiently cool down.
English
45