Publicidad
Idiomas disponibles
Idiomas disponibles
3 Features and Functions
Strain
This section describes how to configure the channels on DAQM909A for strain measurement from the front panel.
1. Connect your desired bridge configuration source to the module's screw terminals.
Full bending bridge:
Half bending bridge:
Quarter bridge:
2. Press [Channel] > Measure, and select STRAIN from the selection menu.
3. Press the Volt Range softkey to specify the DC voltage measurement range. You may choose between 300mV, 1
V (default value), 3 V,or 18V.
144
Keysight DAQ970A/DAQ973A User's Guide
Publicidad
