Descargar Imprimir esta página

ULTIMATE SPEED USWB 11 A1 Instrucciones De Funcionamiento Y De Seguridad página 11

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 172
Do not jam or kink charging
and connection cables.
Do not touch plugs with wet
hands.
When the device is not being
used, always put the cover
caps
on the plugs
9
The device must not be used
if it is not possible to operate
it properly in accordance with
the instructions. Ask the manu-
facturer, a responsible dealer
or an electrician for advice.
The device may only be
connected and adjusted by an
electrician.
CAUTION: How to avoid
accidents and injuries from
electric shock:
Electrical safety:
Adapters or refit adapters must
not be used. Extension cables
must not be used.
Do not carry the device by the
cable. Protect the cable from
heat, oil and sharp edges.
If the cable is damaged, press
the emergency stop switch
immediately
Get an electrician to check the
device. A damaged charging
cable can lead to death or
serious injuries. Before each
use, check the charging cable
.
8
.
5
for damage (e.g. cracks).
Do not use damaged charging
cables.
Do not shortcircuit the contacts
on the T2 plug. This can lead
to a hazardous situation!
Do not put fingers or sharp
objects into the plug contacts.
Do not hold plugs under water
or immerse in water.
When the charging system is
connected, do not clean the
vehicle with a high-pressure
cleaner or wash it as the plug
connection is not resistant to
pressurised water.
z Specific safety
instructions
Before operation, the device
carries out an automatic
self test and checks internal
components, possible residual
currents, over or under voltage
and temperature.
A charging process is then
only possible if all test criteria
have been met.
The product must be installed
in its final location.
If the device is fitted to an
openly accessible post, it
is advisable that you fit an
additional protection round the
post too.
GB/IE/NI/CY/MT
11

Publicidad

loading