Publicidad
Idiomas disponibles
Idiomas disponibles
If required, the emergency stop
switch
can be pressed at any
5
time. "STOP" will be displayed in
red on the digital charging display.
You can go back to the original
state by rotating the emergency stop
switch
anti-clockwise a little.
5
Start the charging process:
Completely unwind the electric
„
car connection cable
The digital charging display
„
indicates that a car is not yet
connected:
The LED strip
and indicates that charging is not
taking place.
Remove the protective cap
„
from the plug
Plug the plug
„
The digital charging display
indicates that a car is connected:
The LED strip
up white.
Start the charging process on
„
the car, if you want to charge
immediately, without using the
car's timer.
Selecting the charge current:
„
Each time you press the button
18
GB/IE/NI/CY/MT
.
7
3
lights up white
4
9
on the car side.
8
into the car.
8
3
continues to light
4
a different charge current will
2
be displayed (charge current
on the display
charge currents can be selected if
only single phase is connected:
9 A
(approx. 2 kW at 230 V)
13 A (approx. 3 kW at 230 V)
16 A (approx. 4 kW at 230 V)
The following charge currents
can be selected, if three phases
are connected (three-phase
current):
6 A
(approx. 4 kW at 400 V)
10 A (approx. 7 kW at 400 V)
13 A (approx. 9 kW at 400 V)
16 A (approx. 11 kW at 400 V)
If the button
„
for 5 seconds, then the selection
is confirmed. The last selected
charge current will always be
stored.
The charging process will now
„
be activated as long as the car's
charging timer is deactivated.
The digital charging display
indicates that the car is being
charged:
The LED strip
up in a circle and this indicates
that current is flowing into
the car.
Otherwise the charging process
will start at the time programmed
). The following
3
is not pressed
2
continually lights
4
10
3
Publicidad
