Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION: P
that there is no voltage in the
power lines to which the
charger
Where possible, the charger
„
should be protected from direct
rain, in order to prevent icing,
damage from hail or similar, for
example. Where possible, do not
position the charger
sunlight.
The charger
„
near the power lines which are
provided for the charger.
Screw the metallic rear panel
„
to the wall using the dowel
and screws
16
To do this you can use the metallic
rear panel
18
(drill plan).
Undo the 7 screws for the back
„
cover
.
19
Remove the back cover
„
put it on one side.
Now hang the charger
„
the metallic rear panel
The hanging holes
mounting the device.
Undo the cable gland
„
Guide the connecting cables
„
through the cable guide
Then push the connecting cables
through the rubber guide
(use sheathed cable).
Undo the 2 screws
„
relief
.
28
lease be sure
will be connected!
1
in direct
1
should be fitted
1
17
.
as a template
and
20
onto
1
.
18
are used for
21
.
27
.
27
15
of the strain
29
Guide the electric cable under the
„
strain relief
Single conductors must not be
„
used for voltage supply.
Only use sheathed cable.
Strip the electrical cable by
1
„
approx. 50 mm.
Strip the individual conductors
„
approx. 7 mm.
Connect the electric cable as
„
follows:
Insert the connecting cable into
the cable gland.
Connect electric cable L1 to the
screw terminal of mains connection
L1
.
18
30
Connect electric cable L2 to the
screw terminal of mains connection
L2
.
31
Connect electric cable L3 to the
screw terminal of mains connection
L3
.
32
Connect the neutral electric cable
to the neutral screw terminal
Connect the protective conductor
electric cable to the conductor
screw terminal
.
28
.
34
GB/IE/NI/CY/MT
.
33
13
Publicidad
