Publicidad
Inspecting the Packing and O-ring
The packing and the O-ring make this camera waterproof
to a depth of 5m/16.4ft. under water. In order not to lose
the camera's waterproofing, follow the directions in this
section, "Inspecting the Packing and O-ring". A grain of
sand or a single hair can cause water to leak into the
camera.
"Packing: The orange rubber frame inside the back cover.
O-ring: The black rubber ring inside the battery cover.
1. When you exchange the film or battery, always check to
see that the packing 4, O-ring 2, and any mating
surfaces 1. @ are not scratched or dirty
2. Use a moistened cotton swab to remove any sand, hair,
or other particles from the packing, O-ring, and any
mating surfaces. lf you use the camera when these
components are scratched or dirty, the camera will not
be waterproof and will break when you immerse it in
water. In this case, the camera cannot be repaired.
Replacing packing and O-ring
Please replace the packing and the O-ring every 2 years at
a Canon service facility, even if they are not scratched or
warped. If you frequently use this camera in sandy or dusty
places or underwater, however, we recommend that you
change both every year.
* The packing and O-ring have been specially treated
4h
Please do not wipe the camera with grease.
67
Publicidad
