Publicidad
GB
CE-Declaration
We, Zens B.V., declare under our sole responsibility that the radio equipment wireless charging device,
ZEMSC1A, is in compliance with Directive 2014/53/EU and RoHS Directive 2011/65/EU. The full text of the EU
declaration
of
conformity
is
available
at
the
following
internet
address:
https://www.makezens.com/mediaroom/products/.
Waste Electrical and Electronic Equipment Directive
Waste Electrical products should not be disposed of with household waste. All electronic products with the
WEEE logo must be collected and sent to approved operators for safe disposal or recycling. Please recycle
where facilities exist. Many electrical/electronic equipment retailers facilitate 'Distributor-take-back scheme'
of household WEEE. Check with your local authority or retailers for Designated Collection Facilities (DCF)
where consumers may dispose of their WEEE free of charge.
North America - FCC statement
DECLARATION OF CONFORMITY WITH FCC RULES FOR ELECTROMAGNETIC COMPATIBILITY
Hereby, Zens BV declares that the device, ZEMSC1A complies with Part 18 of the FCC Rules.
Any changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment. This device complies with Part 18 of the FCC Rules.
is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 18 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase
the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV
technician for help. FCC radiated Exposure Statement: This devices complies with FCC radiated exposure
limits set forth for an uncontrolled environment. This transmitter must not be co-located operating in
conjunction with any other antenna or transmitter. During operation the user must keep a minimum
separation distance of 10 cm with RF devices
In the packaging
Single Wireless Charger Extension
Quick install guide
User manual
Extended warranty registration card
Modular series: magnetic connection
The modular series allow combining multiple chargers in order to build your ultimate wireless charger. The
magnetic connection is easy to use. Simply bring the connection of an extension charger in very close
proximity to the connection of the main station (or a second extension charger) and the magnetic system
will automatically connect both chargers.
1
Publicidad
