Beissbarth MT ZERO 6 Touch Manual De Instrucciones página 103

!
The device must be connected to a standard
electrical system that is equipped with a residual-
current-operated circuit breaker with a wire cross-
section of at least 3 mm conforming to European
standards. The customer is responsible for providing
fuse protection for the power connector.
!
A socket is used to connect the machine to the
mains. For this purpose, use the detachable cable
with standard connector supplied with the device.
The connector must always be readily accessible.
!
A two-pole type "C" automatic circuit breaker must
be used to protect the power connection. Single-
pole automatic circuit breakers are not allowed.
!
A motor starter (or similar protective device) must
be installed to protect against short-circuits.
Version Trip
class
230 V, 1 Ph, 50/60 Hz 10
Tab. 1: General overview of motor starters
!
Adhere to the operating conditions in terms of
temperature and environment listed in the "Technical
data" section.
Fig. 45: Connecting the power supply cable to the machine
Beissbarth GmbH
Adjustable Set value
range
4,5 A – 6,3 A 4,5 A
Initial commissioning | MT ZERO 6 Touch | 103
4.13 Ignition
1. Lift the wheel guard fully.
2. Connect the power supply cable to the mains.
i
Make sure the power supply cable is connected
to the machine as described in the "Electrical
connection" section.
3. Switch the machine on with the on/off switch.
Fig. 46: Switching on the wheel balancing machine
4.14 MT ZERO 6 Touch calibration
!
After initial commissioning, a calibration must be
performed.
1. Calibrate the flange.
2. Calibrate the electronic rim distance gauge and sonar.
3. Calibrate the MT ZERO 6 Touch.
4. Perform a reference measurement.
i
The calibration process is described in the
"Calibration" section.
i
If one is present, also calibrate the external laser
display as described in the "Calibrating an external
laser display" section.
en
|
1 695 600 965 2020-02-27