Beissbarth MT ZERO 6 Touch Manual De Instrucciones página 109

Symbols Description
The measured tire dimensions are shown.
Distance between the rim and the wheel
balancing machine
Rim width
Rim diameter
Indicates the number of spokes detected by the
automatic count of the ASD function
i
The first time the machine is switched on, the status
bar will show default information. In that case, the
numerical values for tire dimensions are 0.
i
Once the machine is in use, the information and
measured values registered during the previous
session will be shown.
i
The measured values will be updated after the first
work phases as described in the following sections.
Beissbarth GmbH
Wheel balancing | MT ZERO 6 Touch | 109
8. Wheel balancing
8.1 Important notes on balancing
DANGER – incorrectly balanced wheels!
Risk of injury due to changes in vehicle handling
characteristics.
¶
The MT ZERO 6 Touch must rest on a flat
surface and be firmly bolted to the ground.
¶
The specified flange must be fitted to a
clean and grease-free machine shaft.
¶
Use the specified accessories (cone,
spacer rings).
¶
The rim must make proper contact with
the flange. Remove any dirt.
¶
If many corrections are needed to calculate
and position the balance weights, calibrate
the wheel balancing machine.
¶
Perform a reference
attaching balance weights.
Designations used:
Designation Description
Distance Distance between the rim and the
MT ZERO 6 Touch
Rim diameter Measured wheel diameter or rated wheel
diameter specified on the rim
Rim In the standard programs, this value
width corresponds to rim width,
for ALU2 (PAX2) and ALU3 (PAX3), it
corresponds to the
distance between the 2 balancing planes.
1st balancing Balance weight nearest to the rim distance
plane gauge in resting position.
= weight on inside
2nd balancing Balance weight farthest from the rim
plane = weight on distance gauge in resting position.
outside
Tab. 2: Designations used
i
The balancing plane is the plane on which the
balance weight is attached.
i
The position of the balancing planes depends on
which program is selected.
i
Static balancing is recommended for wheels with a
rim width of less than 3.5". In this case, only the rim
diameter value is entered.
i
The distance and width values of the rim for the
imbalance measurement can be changed before
starting on the data collection screen. Also, the
units can be switched from "mm" to "inches" and
back on the computer.
en
measurement after
|
1 695 600 965 2020-02-27