Beissbarth MT ZERO 6 Touch Manual De Instrucciones página 104

en 104 | MT ZERO 6 Touch | Fitting and removing the flange
5. Fitting and removing the
flange
The flange must be fitted in the following situations:
R
Initial commissioning
R
Change of flange type (universal – 3-4-5-hole*)
R
Change of wheel type (passenger car – motorcycle*)
* Special accessories
!
Balancing accuracy will be affected if the flange has
not been properly fitted to the shaft. Before fitting
the flange, clean and degrease (remove corrosion
protection) the cone of the shaft and the flange
opening.
5.1 MT ZERO 6 Touch AWx
5.1.1 Removing the flange
i
The wheel balancing machine must be switched on.
1. Push the pedal down.
 This will lock the shaft.
2. Slacken off the hex socket head cap screw.
Fig. 47: Slackening off the hex socket head cap screw
3. Loosen the flange by tapping it on the cone end with
a rubber mallet.
4. Pull the flange off the cone.
Fig. 48: Pulling the flange off the cone
"
Flange detached.
|
1 695 600 965 2020-02-27
5.1.2 Fitting the flange
i
Clean and degrease the shaft and the flange
opening.
i
The wheel balancing machine must be switched on.
1. Push the pedal down.
 This will lock the shaft.
2. Slide the flange onto the shaft.
Fig. 49: Sliding the flange onto the shaft
3. Tighten the hex socket head cap screw.
Fig. 50: Tightening the hex socket head cap screw
"
Flange fitted.
Beissbarth GmbH