Beissbarth MT ZERO 6 Touch Manual De Instrucciones página 105

5.2 MT ZERO 6 Touch AWxP
5.2.1 Removing the flange
i
The MT ZERO 6 Touch AWxP must be switched on.
1. Slacken off both screws on the coupling ring with a
wrench (13 mm).
2. Turn the coupling ring.
 Both screws are located on the left-hand side of
the holes.
3. Push the pedal up.
 The piston (flange) will be extended.
4. Loosen the flange by tapping it on the cone end with
a rubber mallet.
5. Pull the flange off the cone until both screws are
clear of the coupling ring.
1
3
6. Unscrew the flange from the shaft (setscrew).
"
Flange detached.
Beissbarth GmbH
Fitting and removing the flange | MT ZERO 6 Touch | 105
2
5.2.2 Fitting the flange
1. Switch on the MT ZERO 6 Touch AWxP using the on/
off switch.
2. Push the pedal up.
 The shaft (setscrew) will be extended.
3. Slide the flange onto the shaft.
4. Screw the shaft fully into the flange.
Only tighten lightly!
5. Slide the flange over the cone towards the coupling
ring until the two screws enter the left side of the
holes.
3
1
6. Push the pedal up.
 The shaft (setscrew) will be retracted.
 The heads of the screws are now behind the cou-
pling ring.
7. Turn the coupling ring.
 Both screws are located on the right-hand side of
the holes.
8. Tighten both screws with a wrench (13 mm).
"
Flange fitted.
en
2
|
1 695 600 965 2020-02-27