Beissbarth MT ZERO 6 Touch Manual De Instrucciones página 132

en 132 | MT ZERO 6 Touch | Imbalance minimization
Phase 2
Symbols Description
After a tap on the symbol, the basic balancing
screen will be displayed and the OPT function will
not be continued.
By a tap on the symbol, the software will receive
confirmation that the corresponding process has
been carried out and proceed with the next phase.
1. Turn the wheel until the tire valve is in the 12-o'clock
position.
2. Tap the symbol.
 The reference position of the wheel will be saved
on the first start.
Phase 3
1. Mark the tire for reference (at the position of the
valve).
2. Remove the wheel from the flange.
i
In order to rotate the tire on the rim, it may be
necessary to deflate it, unseat it (using a tire
changing machine) and to re-inflate it after rotating.
3. Tap the symbol.
|
1 695 600 965 2020-02-27
Phase 4
1. Rotate the tire on the rim by 180 degrees so that the
mark is across from the valve.
2. Re-assemble the wheel by fitting the tire correctly
on the rim and inflating it to the specified pressure.
!
Do not change the positioning of the valve across
from the mark.
3. Tap the symbol.
Phase 5
1. Attach the wheel to the wheel balancing machine.
2. Turn the wheel until the tire valve is in the 12-o'clock
position.
3. Tap the symbol.
 The new position of the wheel on the flange will
be saved.
Phase 6
4. Close the wheel guard, and use the
confirmation.
 The measurement will start.
symbol for
Beissbarth GmbH