Beissbarth MT ZERO 6 Touch Manual De Instrucciones página 106

en 106 | MT ZERO 6 Touch | Attaching and removing a wheel
6. Attaching and removing a
wheel
WARNING – wheel may slip!
Risk of crushing of fingers and other body
parts when attaching and removing the
wheel.
¶
Wear protective gloves.
¶
Wear safety shoes.
¶
Do not reach between the wheel and shaft.
¶
Always use two people to attach heavy
wheels.
6.1 MT ZERO 6 Touch AWx
6.1.1 Attaching a wheel
1. Switch on the MT ZERO 6 Touch AWx using the on/
off switch.
 Wait for the software to load completely.
2. Position the correct cone on the shaft (flange).
Fig. 51: Positioning the correct cone on the shaft (flange)
3. Remove any dirt with a wire brush.
4. Rest the wheel on the shaft at the cone.
5. Slide the disengaged quick-locking ring onto the
shaft, and press it firmly against the wheel.
Fig. 52: Positioning the disengaged quick-locking nut on the shaft
|
1 695 600 965 2020-02-27
6. Release the lock, and turn the quick-locking ring
clockwise until the wheel is firmly held in place.
Fig. 53: Turning the quick-locking nut counterclockwise
"
Wheel secured.
i
For high-quality balancing, it is essential to tighten
the quick-locking nut securely.
!
Make sure the wheel is held in place securely by the
clamping device.
6.1.2 Removing a wheel
1. Turn the quick-locking nut counterclockwise, and
release the wheel.
2. Disengage and remove the quick-locking nut.
3. Remove the wheel.
Beissbarth GmbH