Beissbarth MT ZERO 6 Touch Manual De Instrucciones página 96

en 96 | MT ZERO 6 Touch | Initial commissioning
3. Insert the screws included in the scope of delivery
into the upper holes on the back of the housing.
Fig. 14: Back of housing
4. Position the screws, leaving at least 5 mm of space
between the structure's wall and the washer.
≥5mm
Fig. 15: Positioning the top screws
5. Anchor the protective hood of the moving unit by
aligning the top holes of the unit with the screws
previously put in place.
!
Make sure not to crush the cables extending from
the bottom of the unit.
|
1 695 600 965 2020-02-27
6. Push the unit down, and make sure the screws are
1
i
M10x35
1
Fig. 16:
7. Insert the screws included in the scope of delivery
1
Fig. 17:
8. Tighten the top screws on the holes in the unit with
Fig. 18:
positioned correctly and as far in the holes as they
will go.
The unit must be parallel to the structure.
Anchoring the moving unit
into the lower holes, but do not tighten them.
Positioning the bottom screws
the tool.
Tightening the top screws
1
M10x35
1
Beissbarth GmbH