Beissbarth MT ZERO 6 Touch Manual De Instrucciones página 118

en 118 | MT ZERO 6 Touch | Wheel balancing
2. Read off the rim width.
3. Tap the numerical value of the
show the numerical evaluation device.
4. Enter the read-off value.
5. Confirm the value entered to return to the data
collection screen.
"
All the necessary rim data have been recorded.
8.9.2 ALU2 (PAX2) and ALU3
Alu2
i
The procedure for entering the wheel data depends
on the balancing program selected.
To balance the wheel, the following parameter values
must be entered for the wheel:
$
Distance: This is the distance between the first
balancing plane and the machine.
$
Diameter: This is the nominal diameter indicated
on the rim.
$
Width: This is the distance between the 2
balancing planes.
!
The position of the balancing planes depends on
which program is selected.
Measuring rim distance, diameter and width
automatically
1. Open the data collection screen from the "Home"
main screen.
Fig. 80: Main screen ("Home")
1 Open the data collection screen
2. Select the balancing program (see sec. "Selecting
the balancing program manually").
|
1 695 600 965 2020-02-27
parameter to
Alu3 Pax2
1
i
Follow the instructions on the monitor if applicable.
The software will respond directly to movement
of the electronic rim-distance gauge and provide
immediate feedback to the user.
3. Place the electronic rim-distance gauge for rim
distance and rim diameter at the first balancing
plane and hold in position for one second.
i
An audible signal will confirm that the position has
been acquired.
4. Without returning the electronic rim-distance gauge
to its resting position, now place the rim-distance
gauge at the second balancing plane and hold in
position for one second.
i
An audible signal will confirm that the position has
been acquired.
5. To end measurement, simply return the rim-distance
gauge to its resting position.
"
The individual values have now been read in and are
displayed on the data collection screen on the monitor.
Measuring rim distance and diameter manually
Identical to the manual measurement for the Standard,
ALU1, ALU4, ALU5 and PAX1 balancing programs as well
as all static balancing programs.
Measuring rim width manually
i
The manual rim-distance gauge can be used to
determine the rim width (distance between the
two balancing planes) in the Alu2, Alu3 and Pax2
balancing programs and to easily position and attach
the adhesive balance weights.
Beissbarth GmbH