Publicidad
Idiomas disponibles
Idiomas disponibles
Important
Retrofitting a tow bar to your vehicle increases the demand on its cooling system.
As a result, the cooling system components will need to be replaced in accordance with the in-
formation held by workshop technicians in authorised ŠKODA AUTO specialist service centres.
The additional tow bar that is fitted is designed to couple trailers in accordance with the restric-
tions specified in the vehicle registration document.
The tow bar has been manufactured in accordance with approved documentation and complies
with homologation E1 55R-01 2601.
Applies only to vehicles exported to Australia
The tow bar is designed to couple trailers in accordance with the information on the sticker
(G1). The tow bar has been manufactured in accordance with approved documentation and
complies with homologation ADR 62/02, AS 4177.1 and E1 55R-01 2601.
General information
The tow bar has been designed to comply with all Czech and international regulations and has
passed the mandatory strength tests imposed by EU directives. The ball hitch with integrated
13-pin socket is fitted with a towball with a diameter of 50 mm.
Component index for the tow bar set with electrical installation – fig. 1
Component
Component
Tow bar with electrical installation Bolts
Control unit
Plastic nut
Frame
Switch
Label for tow bar and B-column
Fitting instructions
Component index for the wiring harness for vehicles not set
up for a tow bar (565 971 658G) – fig. 1
Component
Wiring harness for tow bar
2-pin protection connector
4-pin protection connector
Connecting cable
Cover for connecting cable contact
15 A ATO fuse
25 A ATO fuse
Cable tie with snapper
Cable tie
Quantity
Item
1
A
4
B
1
C
2
D
1
E
1
F
1
G1
1
Quantity
Item
1
H
1
J
1
K
1
L
1
M
2
N
2
P
4
R
35
S
Publicidad
