GLOBBER E-MOTION 14 Manual Del Propietário página 5

3 - CONTROL FUNCTIONS
SCREEN FUNCTIONS
Battery charge level indicator
Fault display
ON/OFF FUNCTION
- To start the scooter, press once the ON/OFF button located at the top of the handlebar. Always remember to press the ON/OFF
button to start the scooter.
- When the LCD screen lights up, the scooter is in "ON" mode. The LED side light and the taillight will light up. The deck is also
equipped with LED lights on both sides that light up in ON mode.
- To turn off the scooter, press and hold the ON/OFF button until the LCD screen and taillights turn off; release the ON/OFF button
and the LED side lights will also turn off.
- Your E-MOTION 14/E-MOTION 210 will automatically turn off after 10 minutes of inactivity.
START-UP
Once the scooter is in ON mode, it is now ready to use. Two actions are necessary to engage the motor:
- Press the throttle accelerator (located on the right handlebar) to start and accelerate. Kick start to activate the motor.
- Push your scooter to reach a speed of 3 km/h.
- Be aware that once the motor is turned ON, reducing your speed below 3 km/h does not automatically turn off the motor; read the
"STOP" paragraph section for instructions on how to turn off the motor.
HOW TO RIDE THE SCOOTER
- Make sure the scooter is in "ON" mode.
- Place your feet on the deck.
- Push the scooter with your foot until you reach a speed of 3 km/h to engage the electric motor.
- Press the throttle accelerator (located on the right handlebar) to start and accelerate.
- The maximum speed is 15km/h in speed mode 2 and 6km/h in speed mode 1.
- To slow down, you can simultaneously or independently:
- Carefully press the handbrake while keeping both hands on the handlebar.
- Release the throttle accelerator while keeping both hands on the handlebar.
- Important: The taillight has a brake function. Each action of the rear foot brake will engage the brake light, and the taillight will then
light up brighter to indicate the braking.
STOP
- To stop, press the brake lever on the left side of the handlebar to engage the rear wheel brake. The action of the brake lever will
simultaneously engage the electromagnetic motor brake, the mechanical brake of the rear wheel and the brake light.
- A t any time, you can remove your finger from the acceleration throttle to automatically shut down the motor, for example in an
emergency. The battery will automatically turn itself off when the motor is not engaged for more than 10 minutes.
Brake handle
Bell
LCD screen
Speedometer
Speed unit display
Light mode
Speed mode 1
On/Off button
Short press the On/Off button to turn on the front light;
Throttle button
double-clicking the on/off button to switch between speed
mode 1 and speed mode 2.
ENGLISH
5