GLOBBER E-MOTION 14 Manual Del Propietário página 6

SPEED MODE SELECTION
When you first press the ON/OFF button, the scooter is by default in "speed mode 2". When the scooter is in "ON" mode, but the
motor is not engaged, the scooter is in "standby mode".
In standby mode, you can switch between the 2 speed modes by double-clicking the ON/OFF button.
Speed mode 1
To switch from "speed mode 2" to "speed mode 1", double-click the ON/OFF button. The LCD screen will show the pedestrian
symbol. The taillight will start flashing in red, and the LED lights on both sides of the deck will flash, showing that the scooter is now
in "speed mode 1". The max speed in this mode is 6km/h.
To switch back to "speed mode 2" from "speed mode 1", double-click the ON/OFF button again. The LCD screen will not show the
pedestrian symbol. The taillight will stop flashing, and the LED lights on both sides of the deck will flash slowly, showing that the
scooter is now back in "speed mode 2". The max speed in this mode is 15km/h.
HEADLIGHTS
Light mode
4 - ASSEMBLY
UNFOLD THE SCOOTER
1. Simultaneously press down the red button on the front of the deck and pull the clamp up, then
raise the t-bar until the folding mechanism is engaged; make sure you hear a "click" sound.
2. Connect the main cable. Then, insert the T-bar into the stem and tighten the bolts. The required clamping/tightening force is
between 5 to 7 N/m.
ENGLISH
6
1. Speed mode 2 (default mode): max speed is 15km/h. The
LCD screen and taillight will continuously light up, while the
side LED lights will flash slowly.
2. Speed mode 1: max speed is 6km/h. The taillight and side
LED lights will flash. The LCD screen will show the pedestrian
symbol.
- Short press the ON/OFF button to turn on the front light. The
LCD screen will show the light mode symbol.
- To turn off the headlights, short press the ON/OFF button again.