Samsung NSG6 87 Serie Manual Del Usuario página 49

To delay starting a self-cleaning cycle
1. Repeat steps 1 and 2 on the previous page.
2. Select Set Delay Start.
3. Set the time you want the oven to start self-cleaning using the dial knob.
4. Tap Start. The oven will start self-cleaning at your specified time.
To cancel the self-cleaning cycle
You may find it necessary to stop or interrupt a self-cleaning cycle due to smoke in
the oven. To turn off the self-cleaning cycle, tap Off. The cycle turns off, but the door
remains locked and the Lock icon blinks until the oven temperature falls below 400 °F
(200 °C).
After self-cleaning
• The door stays locked until the internal oven temperature falls below 400 °F.
• When the oven has cooled down, wipe the oven surfaces with a cloth to remove ash residue.
• Stubborn stains can be removed using a steel-wool pad. Lime deposits can be
removed using a vinegar-soaking cloth.
• If you are not satisfied with the cleaning results, repeat the cycle. Wait until the oven
cools down, and then start a new cycle.
• The cooling fan automatically runs for certain amount of time after self-cleaning.
• Self-cleaning does not operate within 2 hours after running the self-cleaning cycle.
CAUTION
Do not attempt to open the oven door immediately after the self-cleaning cycle is
complete. The oven is still very hot when the door unlocks. Escaping hot air or steam
could burn you.
Replacing the oven light
Oven light
The oven light is a standard 40-watt appliance bulb. It comes on when you open
the oven door.
Remove Remove Replace Replace
Bulb Bulb
Glass bulb cover Glass bulb cover
CAUTION
To prevent electric shock, make sure the oven is turned off and cool before
replacing the oven light.
NOTE
• The oven light does not operate during the self-cleaning cycle.
• Remove the racks if they prevent you from accessing the oven light.
1. Turn off the oven.
2. Make sure the oven and oven light are
cool.
3. Open the door, and remove the glass
cover by turning it counterclockwise.
4. Remove the oven light from the socket
by turning it counterclockwise.
5. Insert a new 40-watt appliance bulb into
the socket, and then turn it clockwise to
tighten.
6. Reinsert the glass cover, and then turn it
clockwise to tighten.
English 49