JMA SUPRACODE Manual De Instrucciones página 38

7.2 LANGUAGE SELECTION
1) Select "Settings".
2) Select "Language and text input".
3) Select "Language".
4) Scroll and select the desired language.
38
5) To exit the menu, press on the circular symbol.
NOTE: For all the machine functions, follow the instructions in JMAKeyPro2.0
and the manual.
For other actions, follow the instructions in the tablets quick guide.
8.- TECHNICAL SUPPORT
JMA Alejandro Altuna has a technical service for all SUPRACODE machine
customers.
To ensure full safety of the operator and the machine, any tasks not specified
in this manual should only be carried out by the manufacturer or technical
service. In case of doubt about operating the machine, contact the address
specified at the back of the manual.
9.- CLEANING AND SAFETY
We recommend following these guidelines for cleaning:
• Keep all the working parts of the machine as clean as possible.
• Use brushes to remove swarf detached during machining.
• Do not use compressed air for cleaning the swarf, as the swarf
could enter the working parts.
The following recommendations are provided for your own safety:
• Do not attempt to start or operate the machine until all
safety, installation, operation and maintenance instructions and
procedures have been followed and understood.
• Always disconnect the power supply before carrying out any
cleaning or maintenance.
• Work with dry hands.
• Make sure the machine is earthed.
10.- MAINTENANCE
Before undertaking any maintenance, the following requirements must be met:
• Do not carry out any operations while the machine is running.
• The power cable should be disconnected first.
• The instructions in this manual should be followed carefully.
• Use original spare parts.
The machine does not require any maintenance in particular, only an inspection
and if necessary, the replacement of parts that are worn, such as: cutters,
clamps, tracers, engravers, etc.
For preventative maintenance of the machine, use lubrication products. Do not
allow the product to come into contact with electronic parts.