English
1
N
if engine trouble occurs, first check
whether use of intake air pre-
heating is necessary
N
at higher temperatures, close the
opening with stoppers (1) (special
accessory)
30
Starting / Stopping the
Engine
Positions of the Master Control lever
STOP
0
Stop 0 – engine off – ignition is switched
off
Operating position F – engine is
running or can start
Warm start n – this position is for
starting the warm engine – the Master
Control lever returns to the operating
position when the throttle trigger is
squeezed
Cold start l – this position is for
starting the cold engine
Adjust Master Control lever
The throttle trigger interlock and throttle
trigger must be pressed simultaneously
to adjust the Master Control lever from
operating position F to starting
acceleration n or choke shutter
closed l.
Position choke shutter closed l
–
If engine is cold
–
if the engine stalls during opening of
throttle after starting
–
the fuel tank has run empty (engine
stalled out)
Position starting acceleration n
–
if engine is warm (once the engine
has been running for approx. one
minute)
–
when engine begins to fire
–
after ventilation of the combustion
chamber, if the engine was flooded
Holding the chain saw
There are two ways to hold the chain
saw during starting.
MS 880