Publicidad
Idiomas disponibles
Idiomas disponibles
To adjust the adjustable bar
1. Turn the adjustment levers of the adjustable bar (A)
counterclockwise, until the adjustable bar can rotate
freely.
B
A
2. Put the adjustable bar (B) into correct work position.
3. Turn the adjustment levers of the adjustable bar (A)
clockwise unti they are fully tightened.
To engage and disengage the parking
brake
•
Pull the parking brake lever rearward to engage the
parking brake. Refer to
for the location of the parking brake.
Note:
The product must be stationary when you
engage the parking brake.
•
Push the parking brake forward to disengage the
parking brake.
To disengage and engage the drive
system
CAUTION:
system when the product is parked on level
ground.
If it is necessary to move the product by hand, with the
engine off, the drive system must be disengaged.
12
A
Product overview on page 3
Only disengage the drive
1. Remove the cover of the hydraulic pump.
2. Turn the bolts of the bypass valves a maximum
of 2 turns counterclockwise to disengage the drive
system. Use a 5/8 in wrench.
3. Turn the bolts of the bypass valves fully clockwise
to engage the drive system for correct operation.
Torque the bolts of the bypass valves to 110-130
in-lb / 12.4-14.7 Nm.
4. Install the cover of the hydraulic pump.
To set the cutting deck in transport
position or mow position
The cutting deck must be in transport position during
transportation.
•
Pull back the deck lifting lever (A) fully. The transport
latch lever (B) locks the deck lifting lever in transport
position.
B
•
Push the transport latch lever (B) forward to lower
the cutting deck into mow position.
To set the cutting height
1. Set the cutting deck in transport position. Refer to
To set the cutting deck in transport position or mow
position on page 12 .
A
2374 - 001 - 26.02.2024
Publicidad
