Husqvarna V548X Manual Del Usuario página 21

9. Adjust the 2 rear nuts until the rear blade tips are set
1/4–3/8 in. / 6.4–9.5 mm higher than the center blade
tips.
10. Measure the distance between the ground and the
front and rear edges of the cutting deck. Make sure
that the rear edge is 1/5 in. / 4–6 mm higher than the
front edge.
To adjust the neutral position
The pump must set the drive system into a neutral
position when the operator releases the control levers.
1. Make sure that the drive system is engaged.
2. Put support below the product. Make sure that the
drive wheels can move freely.
3. Remove the control linkage from the control arm (A).
4. Start the engine and increase the engine speed to
full engine speed.
5. Do a check if the axle turns.
6. If the axle does not turn, do the steps that follow:
a) Stop the engine.
b) Install the control linkage to the control arm (A).
7. If the axle turns, do the steps that follow:
a) Use a 1/4-in hex key to loosen the adjustment
screw (B) to make it possible to adjust the control
arm (A).
b) Move the control arm until the wheel does not
turn.
c) Torque the adjustment screw to 180-220 in-lb
(20.3-24.9 Nm).
d) Make sure that the wheel does not turn.
e) Stop the engine if the wheel does not move.
f) Install the control linkage to the control arm (A).
8. Adjust the neutral position of the wheel on the
opposite side of the product if it is necessary.
9. Remove the support and lower the product.
To do a check of the neutral switches
1. Engage the parking brake.
2. Remove the operator cushion.
2374 - 001 - 26.02.2024
3. Do a check of the left and right neutral switch
4. Make sure that the control levers are in the neutral
5. Adjust the neutral switch mechanism if the roller is
To adjust the neutral switches
1. Engage the parking brake.
2. Remove the operator cushion.
3. Remove the lower bolt on the bellcrank.
B
A
4. Rotate the bellcrank until the roller is in the groove.
5. Install the bolt in the hole that aligns with the control
6. Make sure that the engine starts.
7. Adjust the tracking speed. Refer to
To examine the blades
•
To replace the blades
1. Remove the blade bolt.
2. Assemble the new blade with the side without
3. Attach the blade bolt. Torque the bolt to 90 ft-lb / 122
mechanism.
position.
not in the groove on the bellcrank. Refer to
the neutral switches on page 21 .
rod.
tracking speed on page 15 .
CAUTION:
balanced blades can cause damage to the
product. Replace damaged blades. Let an
approved service agent help you sharpen
and balance blunt blades.
Look at the blades to see if they are damaged and if
it is necessary to sharpen them.
stamps in the direction of the cutting deck.
WARNING:
can cause objects to eject from the
cutting deck and cause serious injury.
Use only approved blades.
Nm.
To adjust
To adjust the
Damaged or incorrectly
Incorrect blade type
21