Publicidad
Idiomas disponibles
Idiomas disponibles
To replace the hydraulic oil and the oil
filter
WARNING:
very hot during operation and can cause
burn injuries. Let the product become cool
before you drain the oil.
WARNING:
you spill engine oil on your body, clean with
soap and water.
1. Park the product on level ground and stop the
engine.
2. Loosen the knob and tilt the pump cover for the
hydraulic tank.
3. Clean the area around the oil openings in the
hydraulic oil tank.
4. Put a container below the oil drain plug.
5. Remove the oil drain plug and drain the oil into the
container.
2374 - 001 - 26.02.2024
The hydraulic oil becomes
Use protective gloves. If
6. Turn the oil cap (A) counterclockwise and remove it.
A
7. Turn the oil filter counterclockwise and remove it.
8. Lightly lubricate the rubber seal on the new oil filter
with oil.
9. Turn the oil filter clockwise by hand until the rubber
seal is in position, then tighten a half turn more.
10. Install the oil drain plug.
11. Fill the hydraulic oil tank with new oil. Refer to
Technical data on page 31 .
12. Install the oil cap (A).
13. Do a check of the hydraulic oil level. Refer to
replace the hydraulic oil and the oil filter on page 25 .
To
25
Publicidad
