Publicidad
Idiomas disponibles
Idiomas disponibles
2. Remove the clutch stop to get access to the pump
belt.
3. Disconnect the clutch wire.
4. Remove the belt from the engine and the pump
pulleys.
To install the pump belt
1. Put the pump belt around the pulley on the engine
and then around the left pump pulley.
2. Put the pump belt around the inner side of the idler
pulley.
3. Move the idler pulley back and hold it and put the
pump belt around the right pump pulley.
4. Install the clutch stop.
5. Install the deck drive belt. Refer to
drive belt on page 22 .
6. Do a check of the tension of the pump belt. Adjust
the belt tension until the spring is extended to a
length of 6.8 in (17.3 cm).
7. Turn the nut on the eye bolt on the idler pulley to
adjust the tension of the pump belt.
To do a check of the engine oil level
1. Park the product on level ground and stop the
engine.
2374 - 001 - 26.02.2024
To install the deck
6.8 in (17.3 cm)
2. Pull open the operator cushion to get access to the
engine.
3. Loosen the dipstick and pull it out.
4. Clean the oil from the dipstick.
5. Put the dipstick in the hole for the dipstick and
tighten it.
6. Loosen and pull the dipstick out and read the oil
level.
7. The oil level must be between the marks on the
dipstick. If the level is near the ADD mark, fill oil to
the FULL mark.
8. Fill the oil through the hole for the dipstick. Fill the oil
slowly.
Note:
Technical data on page 31 for the
Refer to
types of engine oil that Husqvarna recommends. Do
not mix different types of oil.
9. Tighten the dipstick fully before you start the engine.
To replace the engine oil
If the engine is cold, start the engine for 1–2 minutes
before you drain the engine oil. This makes the engine
oil warm and faster to drain.
WARNING:
for more than 1–2 minutes before you drain
the engine oil. The engine oil becomes very
hot and can cause burn injuries. Let the
engine become cool before you drain the
engine oil.
WARNING:
your body, clean with soap and water.
1. Park the product on level ground and stop the
engine.
2. Pull open the operator cushion to get access to the
engine.
3. Remove all dirt around the oil cap.
4. Open the oil cap and remove the dipstick.
Do not operate the engine
If you spill engine oil on
23
Publicidad
