Publicidad
Idiomas disponibles
Idiomas disponibles
4. Carefully push the 2 control levers forward. The
product will start to move forward. The forward
speed increases the more the 2 control levers are
pushed forward.
5. Carefully pull the 2 control levers rearward. The
product will start to move rearward. The rearward
speed increases the more the 2 control levers are
pulled rearward.
6. Put the 2 control levers in neutral position to
decrease the speed and stop the product.
7. Do the steps that follow to turn left or right when you
go in a forward direction.
a) Pull the left control lever rearward in the direction
of the neutral position to make the product turn
left. The more you pull the left control lever
rearward, the more the product will turn left.
14
b) Pull the right control lever rearward in the
direction of the neutral position to make the
product turn right. The more you pull the right
control lever rearward, the more the product will
turn right.
8. Do the steps that follow to make a zero turn.
a) Pull the 2 control levers rearward in the direction
of the neutral position to decrease the speed or
stop the product.
b) Move 1 control lever slightly forward and the
other control lever slightly rearward to make a
zero turn.
9. Lower the cutting deck to mow position. Refer to
To set the cutting deck in transport position or mow
position on page 12 .
10. Pull up the PTO button to engage the drive of the
blades.
11. If it is necessary to adjust the cutting height during
To set the cutting height on page
operation, refer to
12 .
To stop the engine
1. Move the 2 control levers to the neutral position to
stop the product.
2. Push down the PTO button to disengage the drive of
the blades.
3. Engage the parking brake. Refer to
disengage the parking brake on page 12 .
4. Remove your hands from the 2 control levers to
disengage the OPC.
5. Move the throttle control to the minimum throttle
position.
To engage and
2374 - 001 - 26.02.2024
Publicidad
