Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance
Replace the engine air clean-
11
er secondary element.
To clean the product
CAUTION:
washer or a steam cleaner. Water can go
into bearings and electrical connections and
cause corrosion which causes damage to
the product.
Clean the product immediately after use.
•
Do not clean hot surfaces such as the engine,
muffler and exhaust system. Wait until the surfaces
are cool, then remove the grass or dirt.
•
Before you clean with water, clean with a brush.
Remove grass and dirt on and around the
transmission, the transmission air intake, and the
engine.
•
Use running water from a hose to clean the product.
Do not use high-pressure.
•
Do not point the water at electrical components or
bearings. Detergent usually increases the damage.
•
Use compressed air to clean the top side of the
mower deck.
•
Use a water hose to clean below the cutting deck.
•
When the product is clean, start the cutting deck for
a short period to remove remaining water.
To clean the engine and the muffler
Keep the engine and muffler free from grass cuttings
and dirt. Grass cuttings soaked in fuel or oil on the
engine can increase the fire risk and the risk that the
engine becomes too hot. Let the engine cool before it is
cleaned. Clean with water and a brush.
Grass cuttings around the muffler dry quickly and are a
fire risk. Use a brush or remove the grass cuttings with
water when the muffler is cold.
To clean the battery
Corrosion and dirt on the battery and the terminals can
cause the power of the battery to decrease.
1. Remove the battery. Refer to
the battery on page 19 .
2. Flush the battery with water and let dry.
11
In conditions with dust, cleaning and replacement must be done more frequently.
18
Daily maintenance
Before
After
Do not use a high-pressure
To remove and install
Do mainte-
nance at a
minimum of 1
50
time each
year
CAUTION:
pressure washer or a steam cleaner.
Water can go into bearings and electrical
connections and cause corrosion which
causes damage to the product.
3. Clean the terminals and the cable ends of the battery
cables with a wire brush.
To remove the covers
To remove and install the engine cover
The engine cover has a soft operator cushion that
absorbs shocks during operation.
1. Lower the stand on platform. Refer to
product in stand on or walk behind position on page
11 .
2. Pull the handle to open the engine cover fully.
3. Tilt the engine cover slightly up and lift the rear edge
up to remove the engine cover.
4. Install in the opposite sequence.
To do a check of the parking brake
1. Park the product on a slope with a hard surface.
Note:
Do not park the product on a grass slope
when you do a check of the parking brake.
2. Engage the parking brake.
3. If the product starts to move with the parking brake
engaged, let an approved service agent adjust the
parking brake.
4. Disengage the parking brake.
Maintenance interval in hours
100
200
250
Do not use a high-
2374 - 001 - 26.02.2024
300
500
O
To set the
Publicidad
