Husqvarna V548X Manual Del Usuario página 27

Note:
Use a grease gun with a rubber hose when
you lubricate the cutting deck spindles.
Troubleshooting schedule
If you cannot find a solution to your problems in this
operator's manual, speak to your Husqvarna service
agent.
Problem
Engine does not start.
The starter motor does not turn the engine
over.
The engine does not run smoothly.
2374 - 001 - 26.02.2024
Troubleshooting
Cause
The drive of the blades is engaged. Refer to
button on page 4 .
Steering controls are not locked in the neutral position.
The battery is too weak. Refer to
There is dirt in the carburetor or the fuel line.
The fuel filter or fuel line is clogged.
The ignition system is damaged.
Incorrect neutral adjustment. Refer to
on page 21 .
Incorrect operation conditions. Refer to
page 8 .
A fuse is blown. Refer to
The connection between the cable and the battery is bad. Refer to
To remove and install the battery on page 19 .
The battery is too weak. Refer to
Incorrect neutral adjustment. Refer to
on page 21 .
The carburetor is incorrectly set.
The fuel filter or fuel jet is clogged.
Incorrect neutral adjustment. Refer to
on page 21 .
The choke is engaged and the engine is warm.
The check valve on the fuel tank cap is clogged.
The fuel tank is almost empty.
The spark plug is damaged.
Incorrect fuel mixture or fuel type.
PTO (Power Take-Off)
To charge the battery on page 19 .
To adjust the neutral position
Operation conditions on
Fuses on page 5 .
To charge the battery on page 19 .
To adjust the neutral position
To adjust the neutral position
27