Publicidad
Idiomas disponibles
Idiomas disponibles
To charge the battery
•
Charge the battery if it is too weak to start the
Battery charging times on page 32
engine. Refer to
for battery charging times.
•
Use a standard battery charger.
CAUTION:
charger or start booster. A boost charger
or a start booster will cause damage to
the electrical system of the product.
•
Always disconnect the battery charger before you
start the engine.
To do an emergency start of the engine
If the battery is too weak to start the engine, you can use
jumper cables to do an emergency start. This product
has a 12 V system with negative ground. The product
that is used for the emergency start must also have a 12
V system with negative ground.
To connect the jumper cables
WARNING:
of explosive gas that comes from the
battery. Do not connect the negative
terminal of the fully charged battery to or
near the negative terminal of the weak
battery.
CAUTION:
product to start other vehicles.
1. Connect one end of the red cable to the POSITIVE
battery terminal (+) on the weak battery (A).
B
A
2. Connect the other end of the red cable to the
POSITIVE battery terminal (+) on the fully charged
battery (B).
2374 - 001 - 26.02.2024
Do not use a boost
Risk of explosion because
Do not use the battery of the
C
D
WARNING:
the ends of the red cable against the
chassis.
3. Connect one end of the black cable to the
NEGATIVE battery terminal (-) on the fully charged
battery (C).
4. Connect the other end of the black cable to a
CHASSIS GROUND (D), away from the fuel tank
and the battery.
To remove the jumper cables
Note:
Remove the jumper cables in the opposite
sequence to how you connect them.
1. Remove the BLACK cable from the chassis.
2. Remove the BLACK cable from the fully charged
battery.
3. Remove the RED cable from the 2 batteries.
To remove and install the battery
1. Pull open the engine cover to get access to the
battery.
2. Remove the knob from battery bracket and remove
the bracket from the battery.
3. Use 2 wrenches to disconnect the black battery
cable from the negative (–) terminal on the battery.
4. Use 2 wrenches to disconnect the red battery cable
from the positive (+) terminal on the battery.
5. Carefully remove the battery from the product.
6. Install in the opposite sequence.
Tire pressure
Make sure that the tire pressure is correct in all 4 tires.
Refer to
Technical data on page 31 .
Do not short circuit
19
Publicidad
