Publicidad
Idiomas disponibles
Idiomas disponibles
6. Turn the ignition key to the stop position.
7. Remove the ignition key from the ignition when you
are away from the product.
To adjust the tracking speed
1. Pull out the retaining clip from the vertical control
rod.
2. Adjust the coupler until the speed is correct. When
the unit tracks straight and is at correct maximum
forward speed, put the retaining clip into the vertical
control rod to lock the coupler.
To get a good cutting result
•
For best performance, do maintenance on the
product regularly as given in the maintenance
Maintenance schedule on page
schedule. Refer to
15 .
•
Do not cut a wet lawn. Wet grass can give a bad
cutting result.
•
Start with a high cutting height and decrease it
gradually.
•
Use full throttle when you cut the grass.
•
Move the product forward at low speed if the grass is
high and thick.
Introduction
WARNING:
maintenance work you must read and
understand the safety chapter.
2374 - 001 - 26.02.2024
Maintenance
Before you do any
•
Cut the grass in an irregular pattern.
•
When the mulch kit is used, cut the grass more
frequently.
•
To get the best cutting result, cut the grass
frequently.
To do a 3-point turn
A correct turn will prevent damage to the lawn. The goal
is to turn when you move forward or rearward. Do not
turn in a tight circle on a stopped wheel.
1. Cut a row of grass.
2. Make a small turn (A) in the direction of the uncut
area of grass.
C
3. Pull the 2 control levers to the reverse position and
move the product rearward (B).
4. Push the control levers forward. To make a small
turn (C), pull harder on the control lever that is in the
direction of the row you have cut before.
5. Push the 2 control levers forward to cut the next row.
Maintenance schedule
* = The instructions are not given in this operator's
manual.
X = The instructions are given in this operator's manual.
O = Refer to the engine manual for instructions.
B
A
15
Publicidad
