Publicidad
Idiomas disponibles
Idiomas disponibles
To remove and install the front wheels
1. Remove the nut and the bolt to remove the front
wheels from the forks.
2. Install in the opposite sequence. Torque the nut and
bolt to 50 ft-lbs / 67.8 Nm.
To adjust the anti-scalp rollers
The anti-scalp rollers keep the cutting deck in the correct
position on the ground and prevent lawn scalping in
most terrain conditions. The anti-scalp rollers can be set
in 3 positions for different lengths of grass:
•
Top position: 1.5–2.5 in. / 38–64 mm grass.
•
Middle position: 2.5–4 in. / 64–102 mm grass.
•
Bottom position: 4–5 in. / 102–127 mm grass.
1. Park the product on level ground and stop the
engine.
2. Remove the nut, the bolt, the axle and the anti-scalp
roller.
3. Install the anti-scalp roller in one of the 3 positions.
CAUTION:
become damaged if the anti-scalp rollers
are incorrectly adjusted. The anti-scalp
rollers must be approximately 1/4 in. /
6.4 mm from the ground.
20
The cutting deck can
To adjust the parallelism of the cutting
deck
This procedure will set the cutting deck in a standard
position.
1. Make sure that the tire pressure is correct. Refer to
Technical data on page 31 .
2. Make sure that the deck drive belt is correctly
To install the deck drive belt on
installed. Refer to
page 22 .
3. Park the product on a level surface.
4. Put the cutting deck in transport position.
5. Turn the blades to align with the cutting deck side to
side.
WARNING:
cutting deck are sharp and can cause
injury. Use protective gloves.
6. Measure the distance between the ground and the
bottom of the blade tip on the discharge side of the
cutting deck. Make a note of the distance.
7. Measure the distance between the ground and the
bottom of the blade tip on the side opposite to the
discharge side. The distance must be the same as
the distance for the discharge side. If adjustment is
necessary, adjust the 2 front nuts until the 2 side to
side distance are equal. Tighten the 2 front nuts.
8. Turn the blades to align with the cutting deck front to
rear.
The blades on the
2374 - 001 - 26.02.2024
Publicidad
